Co2 Laser Alignment Tool For "PERFECT" lens head & mirror alignment ZnSe Si Mo GaAs K40, 16-25mm Click to see Videos!!!
For PERFECT lens head and mirror alignment.
Measure the diameter of your lens tube to select the right alignment tool.
The always on red laser make alignment quicker and safer.
Align the 3rd and most critical mirror first.
Aligning the 2nd mirror, this tool will give you the perfect location for your tube.
The 1st mirror (next to the tube) will be aligned using conventional methods.
The Reverse laser Aligner is designed to represent the exact center of the lens at 90 degrees +/- 10 minute perpendicular.
For any reason you are not satisfied with this product return it for a full refund!!!!!!
How to select the correct Reverse Laser Aligner.
a- Remove lens tube and insert reverse alignment tool.
b-Align mirror 3 on the head to mirror 2 on gantry (both near and far till the red dot doesn’t move).
a- Align mirror 2 on the gantry to mirror 1 next to the laser (both near and far until the red dot does not move). Mirrors 2 and 3 are perfectly aligned!
b- Lock them down and do not touch them again!
a- With tape on mirror 1 mark a target spot where the red dot hits it.
b- Now remove the alignment tool.
a- Adjust the laser tube to hit the target spot on mirror 1. (The tube does not need to be level).
b- Adjust the front and back supports independently to hit the target spot.
a- Reinstall the reverse alignment tool.
b- Put tape over the laser entry hole on the laser head.
c- Mark a target spot where the red dot hits the back side of the tape.
d- Remove the alignment tool.
a- Adjust mirror 1 both near (top nearest corner to the laser tube) and far (farthest corner from the laser tube) to the target spot on the laser head.
A problem you might find with your machine with this process.
The 4 corners of your gantry may not be level.
When aligning mirror 3. Get it perfect near the front of your machine and then move it to the back.
If it is no longer perfect your gantry is not level (your floor is not level).
You are going to need to adjust the 4 corners of your machine to get your gantry level first.
Why the 3rd mirror alignment is the most important.
Reverse Laser Aligner instruction video.
We Also Recommend
Silicon Si Mirror Co2 laser 1pc or 3pc set 19, 20, 25, 25.4mm High Durability 99.7% Coating 40W-200W
Co2 Laser red dot position <5mw 650nm 3-5VDC diode Engraver cutter machines
15mm ZnSe Focus Lens 1.5mm Edge Thickness Trotec Speedy 100 by APC C02 laser 10.6um